8001 Terrace Ave
Suite #201
Middleton, WI 53562
Phone: 608-831-0880
Toll-Free: 866-4-MATMIX
Fax: 608-831-1833
DIGI-HD-1X4 Installation Manual
The Intelix DIGI-HD-1X4 seamlessly distributes one HDMI input to
four twisted pair outputs using built-in twisted pair extenders to
provide HD video at distances up to 300 feet when used with
compatible Intelix twisted pair receivers, such as the DIGI-HD-
UHR2-R, DIGI-HD-IR2-R, and DIGI-HD-XR.
When distributing HDMI audio and video over twisted pair
cabling, the DIGI-HD-1X4 requires a single Cat 5e or Cat 6 cable.
When distributing HDMI audio and video and IR over twisted pair
cabling, the DIGI-HD-1X4 requires two Cat 5e or Cat 6 cables. IR is
transmitted from the display location, through the compatible
Intelix twisted pair receiver, over the twisted pair cable, and out
of the IR OUT port on the DIGI-HD-1X4 to the source equipment.
The DIGI-HD-1X4 supports 3D, is HDCP compliant, and features
proprietary Intelix HDshāk processing, including bandwidth
limiting and custom EDID configuration and emulation.
Twisted Pair
Wiring - Use
T568B wiring
for Cat5e/6
connection
between send
and receive
units.
Maximum Recommended Distances
Instructions
1. Turn off power and disconnect the audio/video
equipment by following the manufacturer’s
instructions.
2. Adjust DIP switches for desired mode.
3. Connect all twisted pair cables (ensure T568B
straight-thru wiring).
4. Connect HDMI cable between source and DIGI-
HD-1x4 input.
5. Connect power supplies.
6. Power on attached audio/video devices.
Compatible Devices
Compatible Receivers: DIGI-HD-UHR2-R, DIGI-HD-UHR2-WP-
R, DIGI-HD-IR2-R, DIGI-HD-IR3-WP-R, DIGI-HD-XR
Important notice:
Do not attempt to disassemble or alter the extender
housing. There are no user-serviceable parts inside the
unit. Doing so will void your warranty.
To minimize the possibility of equipment damage from
electrostatic discharge (ESD), all source and
destination equipment must be powered off during
installation.
Do not connect the extender to a telecommunication
outlet wired to unrelated equipment. Doing so may
damage the unit or any connected equipment. Ensure
all connected twisted pair cabling is straight-through
(point-to-point).
Allow proper ventilation to reduce the risk of thermal
failure.
Front Panel Indicators
When the unit is in a Dual UTP Mode, LEDs on the
front panel indicate connection with an attached
receiver. When the unit is in Single UTP Mode, LEDs
on the front panel will all be lit to indicate that video is
being sent out all outputs.
(6 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels