Intelix AVDA-8-F Manuel d'utilisateur télécharger pdf

Intelix AVDA-8

AVDA-8 Audio/Video Distribution Amp Balun

Installation Guide

Features: Applications:

Supports NTSC and PAL CCTV Security & Surveillance

Distributed up to 2200 ft. Classroom A/V Instruction

Up to 2 audio & 2 video channels Corporate A/V Presentations

Integrates w/ Intelix A/V Baluns Tradeshow Demonstrations

Looping output to cascade to other

AVDA-8s or A/V equipment

Rubber stand-offs for desktop use

Introduction

The Intelix AVDA-8 Audio/Video Distribution Amp Balun allows up to two (2) baseband video

signals and up to two (2) audio signals to be distributed to up to eight (8) destinations via twisted

pair (UTP) cable for cost-effective and versatile cabling.

When used in conjunction with Intelix’s line of audio/video Baluns, the AVDA-8 allows coaxial

cable to be eliminated between the audio/video source and the destinations. The AVAD-8 is

compatible with Intelix V1, V1-ST, V1A2, V2A2, and SVA2 Baluns.

The AVDA-8 allows the distribution of CCTV and audio/video signals to multiple locations via

standard twisted pair cabling instead of costly coaxial video or audio cable.

Installation

Follow the steps listed below to install the AVDA-8:

1. The Intelix AVDA-8 is polarity sensitive and works in conjunction with Intelix's A/V

Baluns. If the AVDA-8 is used with Baluns which have a signal polarity opposite that of the

AVDA-8, then the signal polarity of the cabling between the distributor and the video Baluns

may need to be reversed. Verify that the pin configuration of the video Baluns match the pin

configuration of the distributor. The pin configuration of the distributor is conveniently

located on the rear panel.

1 2 3 4 5 6

Résumé du contenu

Page 1 - Installation

Intelix AVDA-8 AVDA-8 Audio/Video Distribution Amp Balun Installation Guide Features

Page 2 - Pin Configuration Table

2. Connect the appropriate Intelix video Baluns to the audio/video source and destinations. The AVDA-8 supports up to two video and two audio cha

Page 3 - Power 4Outputs

V1 V1A2 V2A2 SVA2 Signal CCTV Balun Stereo Audio-Video Balun Dual Audio-Video Balun S-Video/ Audio Balun Video 1 7&8 7&8 7&8 7&

Page 4 - Looping Output

6. Connect the cable coming from the audio/video source to the Input located on the back of the AVDA-8. 7. Connect, one at a time, the twisted pair

Page 5 - Troubleshooting

Troubleshooting Reading this section carefully will allow you to pinpoint and resolve any type of malfunction. If after going through this section yo

Page 6 - Specifications

Specifications Source Impedance Requirements Video OUT: 75 ohms Audio OUT: 600 ohms max. Destination Impedance Requirements Video IN

Commentaires sur ces manuels

Pas de commentaire

Intelix AVDA-8-F Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel informatique Intelix AVDA-8-F. Intelix AVDA-8-F User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel informatique Intelix AVDA-8-F