Installation
1. Power off the source and destination devices which will be connected to the baluns.
2. Verify the modular outlets and cross connects to which you will connect the AVO-
VGA are configured properly and labeled appropriately to identify the circuit.
3. Verify the desired twisted pairs are not being used for other LAN or telephone
equipment.
4. Connect the send balun (AVO-VGA-S) to the VGA port of the source equipment.
Tighten the mounting screws on each balun.
5. Connect one end of the twisted pair cable to the send balun. The RJ45 pinout in the
twisted pair cabling should conform to the EIA/TIA 568A or 568B standard.
6. Connect the receive balun (AVO-VGA-R) to the destination equipment.
7. Connect the other end of the twisted pair cable to the receive balun. The RJ45 pinout
in the twisted pair cabling should conform to the EIA/TIA 568A or 568B standard.
8. Power on the source and destination equipment.
9. If necessary, set monitor contrast and brightness to the desired levels.
10. Set the monitor refresh rate to the optimal rate for the display at the desired resolution.
11. If necessary, adjust the image quality with the Sync Adjust switch on the send and
receive baluns. It is recommended that both switches be in the same position.
Caution: Do not connect the balun to a telecommunication outlet wired to
unrelated equipment. Doin
so ma
dama
e the unit or an
connected equipment.
Ensure all connected twisted pair cabling is straight-through (point-to-point).
Caution: To minimize the possibilit
of equipment dama
e from electrostatic
discharge (ESD), all source and destination equipment must be powered off durin
installation. This includes signal extenders, splitters, and switches.
Note: For your convenience, it is recommended that
ou uniquel
mark the ends
of the twisted pair cable before pulling them through a wall or conduit.
Note: The AVO-VGA features an optional grounding screw that may be used to
correct an
ima
e anomalies, such as differences in hue from one side of a monitor to
the next. Should this occur, connect the balun
round to earth
round. However, if the
building has a grounding problem, such as ground loo
s,
roundin
the balun ma
negatively affect the signal. Only ground the AVO-VGA if it positivel
affects the
si
nal.
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels