Intelix FLX-3232 v1.6.4 Manuel d'utilisateur télécharger pdf (Page 14)

FLX-3232 Installation Guide

To use the IR extension capabilities of the FLX-BI4, the DIGIB-EYE (wideband IR receiver) and DIGIB-EMT

(wideband IR emitter) will need to be connected to the appropriate IR ports. These parts are not

included with the HDBaseT I/O cards.

To use the RS232 extension capabilities of the FLX-BI4 and FLX-BO4A, connect the TX, ground, and RX

control signal wires to the removable 3-pole terminal block. Consult the manual of the control device(s)

to determine which pins the TX/RX signals are carried on. Be sure to always connect TX to RX and RX to

TX.

FLX-RI4 Wiring

For VGA signals, use a standard VGA male to VGA male cable.

For RGBHV signals, use a standard VGA to RGBHV cable. Below is a common pinout of this type of cable.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Pas de commentaire

Intelix FLX-3232 v1.6.4 Manuel d'utilisateur Page 14