Intelix DIGI-44B Manuel d'utilisateur télécharger pdf (Page 15)

DIGI-44B Installation Guide

4. Confirm the Docklight communication settings (Docklight -

> Tools -> Project Settings) match the device. 9600/8/n/1

on the COM port named USB Serial Port (or COM 1 if using

your computer’s serial port instead of the adapter.

5. Start Communication.

6. Turn the power to the DIGI-44B on – after 5 seconds, the

DIGI-44B will send some lines of information you can see in

the communications window. This confirms that you are

communicating properly.

7. In the “Send Sequences” window, press the Set IP Mode

DHCP button

8. Verify that the IP address changed in the

communication window. *Note – it can take

5-10 seconds for the unit to report back the

confirmed change.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Pas de commentaire

Intelix DIGI-44B Manuel d'utilisateur Page 15